HeadBolts.com engine hardware store

We have cylinder head bolts (as well as all types of engine fasteners) for gas and diesel engines

Automotive,truck,industrial and inboard marine applications

Free Shipping over $99.00  !

Free shipping on orders over 99.00 dollars for domestic orders only.

  • Browse our aisles by going to categories menu, For all the engine hardware we have for your car ,truck or marine engine

Price: $94.95
Availability: Out of Stock

    Cylinder head bolts

    Ford Y block early to 56 and some 56 with two different bolt lengths

    caution Ford Y block head bolts 239, 256, 272, 292 & 312 engines up to 1956 heads used two different length bolts

    in 56 the a change to 3 different lengths was made. The three bolts in the center under the rocker shaft are the same, The two bolts on the end of each head are longer about a 1/4 inch

    inspect heads before ordering bolt to sure you get the correct ones other wise engine damage could happen

    most up to 56 cylinder head bolts

    set does both heads,

    cylinder head kit made with all arp head bolts and washers fits heads that use two different length head bolts , note that bolts have 1/2 inch wrenching

    These are hi performance head bolts suitable for higher compression and forced induction and are a great upgrade from stock bolts

    torque is 70 foot pounds done in three steps 30, 55 then 70 ft pounds with arp lube included in kit. Cylinder head washer goes inner chamfer side up

    kit contains

    10 long bolts

    10 short bolts

    20 washers

    chbs-1221

    Number of questions: 1
    <p>I am not certain whether I have an early to 56 engine/heads. The engine was replace in 1967 prior to my knowledge of the car. Are there casting numbers or something that will help with this issue?</p><p>Thanks,</p><p>Kent</p>
    Kent January 11, 2015 12:19 PM
    Answers
    well the easy way is to pull out the bolts and compare if you have 3 types or two , or you can look at the cylinder head bolt bosses to see if the three under the rockers are milled to the same height as the two outer ones , or if the head is off the engine measure down from the top of the boss to the bottom of the head , there is 1/4 inch difference on the later head and they are the same on the early heads
    admin63484 January 11, 2015 3:40 PM

    Providing cylinder head bolts and engine fasteners to engine rebuilders  since 1988

    HeadBolts.com 20 mirona rd ext Portsmouth NH 03801

     
    We Accept PayPal and credit cards

    Amex
    Discover
    MasterCard
    Visa

    © 2021 HeadBolts cylinder head bolts and engine fasteners